Heli test / training available. Dave Herbert. The components needed: 1, offset 24 "x 24" to make the base circle. 1, 24 "long and 2x2" wide strips of insulating foam (cut 2x2x2 "square x 21 1 ¼" to about ramin wood auction. 1 ¾ "x 24" galvanized threaded pipe (It must be difficult), the. Reason 1 ¾ "floor flange with four, 1 ½" x 3 / 16 "long screws and nuts to attach it to Ply. 1, 3 / 8" x 2 ½ "Stove Bolt (round head, no slots) 2 large 3 / 8 "washers, and two 8.3" Nuts 2, 3 ½ "long x ¾" wide, slightlySprings 1, ½ "long x 1 / 8" wood screw 1, 5 / 16 small holes (4.1 ") spring washer to the point of contact on the underside of the tail. 1, 3" x 8 "x 3 / 16 "situation, material or other substances for helicopter mounting base plate. 2, ¾ "hose clamps for pole ramin wood. 1, 1" galvanized pipe clamps for 1 ¼ "x 2 ½" long, flat shoulder screw Headed for receiving mounting plate auction Ramin 1, 12 "long mini- bungee rope 8, # 60 rubber bands, four mounted on each side for helicopter landing gear on board. 1, 12 "long nylon"Chalk" make-string belt. Cycle of helicopter frame and mounting plate. Take your time and follow the instructions carefully. 1 Measure the exact middle of the plywood base 24 "x24" and cut a circle is as big as the wood. Sand and paint or stain as desired. 2 Drill the hole to 3 / 8 "bolt and 3 / 8" x 2 "bolt stove ½ (round head toward the floor). Use large washers and nuts on both sides to adjust the length on the floor by 1 ½" of wood, although with 2x 2 x 2 ...
Keywords: Helicopter, Training, test, stand, Honeybee, Blade, 400, Mr.Herbert's, Science, Class, Dave, Herbert, RC, Nightflyyer
No comments:
Post a Comment