How to set up a helicopter RC

The most important step when you fly a RC helicopter is the configuration. If your helicopter is not properly set the bird is an other side of the tip forward or backward, or tail could spiral out of control. You can see how important a good September

1 The first step in building an RC helicopter.

Rc Helicopter

• Make sure that all the servants in the right direction if you want the right stick right to move the swash plate right angle, etc. for the front and rear.
· Makethe accelerator is right and must not vice versa as in the radio TX.

2 Now that the servos move in the right direction, we need to center the servos.

• On the radio, then connect the receiver to ensure that the engine is not connected when working on electric helicopters.
• Move throttle half way to get all these servants on the position halfway.
· Now we want the servo horn, the range will contain about 90 degrees with the center to findmove until you get to close or make dead sure you put the screw, if you find one that works find.

3 Moreover, the swashplate is a tool you can buy for your level of size helicopter, or you can eyeball it. • To level the swash plate fits arms that run from the servos to the swashplate.

4 Therefore, we must ensure that the level of block leaching.

• The washout block is between the swash plate and the cage bars fly.
• Make sure thatBoth arms are on the other, if not adjust the arm bar from the cage to fly level. Presentation Next we need to make sure that the flybar arms level
• Make sure that the flybar arms are parallel to each other, if not regular auction, attaches to the swashplate.

5 So, make sure the field is set for the main rotor blades.

· Guarantee When in the midst of nitrogen, the main rotor blades are at zero pitch
· Full-stick should be between +10Degrees to +12 degrees, depending on the style of flight
Stick · bottom should be -10 degrees to -12 degrees.

Now we have our head setup and ready to go. With all that level, and together we have a stable car in the air, this configuration offers the best chance to go ashore. These are still some things to consider as a step in the curve configuration butterfly curves. Setup radio in general, but this is a topic in itself.

The setup queue can be difficult at times I foundThe best way to get the configuration mode frequency in the queue to get your power to ensure that the barrel center then adjusted my dick with a certain tone in the back position, pushing the nose to compensate for the right engine thrust main take-off and to keep the nose straight into a hover. Details about all I can give, not knowing the servant and gyroscope, which is used.

That all the basic settings of the helicopter are safe and have fun keep it in the air have a great day!

How to set up a helicopter RC

timbuk2 snoop camera bag